|
Modular casework designed and manufactured by |
 |
|
|
SERIES 200 SPECIFICATIONS FRAMELESS WOOD MODULE |
||
|
Type A and/or B Surfaces: Factory-finished hardwood plywood (7-ply minimum) specie is optional and must be specified either P/S Red Oak or R/C uniform Light Maple. Stain selection will be made from samples provided by South Texas Woodmill Hardwood / Hardwood Plywood Surfaces: All finished-end conditions (3/4" thick) All interior parts of open case or cases with full, clear-glass doors All door and door edges All drawer fronts mid drawer front edges 3/4" thick) All bottoms of wall cases 48" or more above floor (3/4" thick) All tops of tall cases less than 72" above floor (3/4" thick) All exposed leg and skirt assemblies All backs that are exposed to view with door closed and open units (3/8" thick & 3/4" thick) Type A Optional: Plastic laminate doors and drawer fronts (Series 201) Type C Surfaces: Factory-finished, softwood plywood (3/4" minimum thickness, 5-ply minimum), suitable for intended uses, specie is optional. Edges match finish selected. All case body and shelves Factory-finished tempered hardboard or mill option plywood All case backs: semi-concealed (l/4" thick) All stretchers (3/4" thick) Type D Surfaces: Optional material all sound and suitable for intended use. Sub-strates: Veneer Core: (7 Ply) Specie as specified. (3/4" thick) Hardboard: Meets or exceeds the latest Federal Specifications and Commercial Standards for "Tempered Hardboard" ‑ smooth two sides. Edges: Hardwood veneer edges or 3mm hardwood edges "specified". Factory Finishes: Type A Surfaces: 1. Sanding (120-grit) 2. Stain (if specified) 3. Sanding sealer 4. Sand (220-grit) stearated paper 5. Two part canalized varnish top coat Type C Surfaces: 1. Sanding (120-grit) 2. Sanding sealer 3. Sand (220-grit) stearated paper 4. Two part catalized varnish top coat General Features and Specifications: See this page for other information, which pertains to all series casework. |
||
