Series 500 Specifications

	Modular casework designed and manufactured by Previous Design Series Picture Diagram Next
SERIES 500 SPECIFICATIONS Conventional Face Front Laboratory Grade Wood MODULE

Type A / B Surfaces: Factory-finished hardwood plywood (7-ply minimum) specie is optional and must be specified either P/S Red Oak or R/C uniform Light Maple. Stain selection will be made from samples provided by South Texas Woodmill Hardwood / Hardwood Plywood Surfaces: All finished-end conditions All interior parts of open case or cases with full, clear-glass doors All bottoms of wall cases 48" or more above floor All tops of tall cases 48" or more above floor All exposed leg and skirt assemblies All doors and drawer fronts All face fronts (3/4" thick hardboard) Type A Surfaces Optional: All door and drawer fronts (Series 501 plastic laminate door and drawer fronts) Type C Surfaces: Factory-finished, softwood plywood (3/4" minimum thickness, 5-ply minimum), suitable for intended uses, specie is optional. Edges match finish selected. All case body and shelves Factory-finished, (1/4" minimum thickness) tempered hardboard All case backs Type D Surfaces: Optional material all sound and suitable for intended use. Edges: All doors and drawer edges 3mm hardwood Factory Finishes: Type A Surfaces: 1. Sanding (120-grit) 2. Stain (if specified) 3. Sanding sealer 4. Sand (220-grit) stearated paper 5. Two part canalized varnish top coat Type C Surfaces: 1. Sanding (120-grit) 2. Sanding sealer 3. Sand (220-grit) stearated paper 4. Two part catalized varnish top coat General Features and Specifications: See this page for other information, which pertains to all series casework.